Lets say Pt 1 is at the calf, pt 2 is at the heel, pt 3 is the big toe and pt 4 is at the little toe when I set up the spline in frame 1 as described above. So I have 8 points around the leg and foot. My next question is how Mocha Pro handles the “Points” that make up the spline. An example would be the foot turning 90 degrees where the start you see the profile of the foot and the end the toes are facing forward so the profile “disapears” I expected Mocha Pro to be able to track this as well but since the cog is not an option I cannot tell Mocha to do track the spline This means I have to keyframe all of these types of changes. This means that although the spline is tracked the changes to the spline due to motion are not. ![]() And now for my questions:īecause I linked the layers, I no longer have the option to track my left leg spline layer. After this spline is complete I then link this layer to the “left leg track” layer. Lets also say the spline has only 8 control points. I then create my spline of the leg, call it “left leg spline” and say I start this at frame one. After a sucessful track I click on the cog to remove it so I don’t accidently overwrite the track. My first layer, call it “left leg track” is a loose spline which the leg stays in throughout the clip, achieved with a few keyframes here and there. I also read that it may be easier to break up the object into sections. I have read that it is easier if your track the object prior to doing the actual spline for the profile in order to help reduce the amount of keyframes to do the actual spline throughout the clip. ![]() My questions below are based on the following scenario involves which involves Rotoscoping and the clip itself is a person dancing with the background which is perfectly still since the camera was placed on a tripod throughout the whole clip. ![]() I have recently purchased Mocha Pro and have been looking at the videos, manual as well as experimenting and I have some basic questions that I can’t seem to figure out and was wondering if anyone can help me out.
0 Comments
Leave a Reply. |